• Warranty Manufacturer’s seven year-warranty, including high pressure and mechanical wash

• Durability Highest performance available polyester-based film resists cracking and lifting. Impact and abrasion resistant

• Construction Single ply .008" thin; NOT open cell construction Impact resistant, withstands a hammer blow and still reflects

• Adhesion 100% surface adhesion

• Angularity Reflects at all applicable angles on the roadway

• Candle Power Minimum 100 cpl typically 1000 cpl. exceeding requirements by four times

• Application Apply wet or dry, adheres to corners

• Specifications Exceeds NHTSA & FHWA specifications, DOT-C2 markings

vsm27S
7-year white DOT tape, 2" x 150’ roll
vsm28
7-year DOT tape, 7" white–11" red, 2" x 150’ roll

vsm27ST
7-year white DOT tape, 2" x 18" strip
vsm28T
7-year DOT tape, 7" white-11" red 2" x 18" strip

Recommended Material Requirements for Non-Continuous Side Pattern

Note: The above table represents minimum amount of material specified by NHTSA. Additional material may be used to improve the overall conspicuity of the vehicle

Features:

• An excellent choice to retrofit older trailers and equipment
• Gives an enhanced daytime appearance on trucks and trailers
• Typically exceeds 600 cpl, 2.5 times greater than DOT-C2
brightness requirements
• Alternating 11" red x 7" white pattern
• Virtually unbreakable; single ply material is.008" thin, no open cells
• Withstands impact damage without losing reflectivity
• 100% permanent surface adhesion
• 3-year manufacturer’s warranty including pressure washing
• Reflects light at all applicable angles on the road
• Can be applied wet or dry

vsm29S
3-year white DOT tape, 2" x 150’ roll

vsm29
3-year DOT tape, 7" white-11" red, 2" x 150’ roll

vsm30
3-year DOT tape, red/white 2” x 150’ roll Kisscut - precut every 18” at color break)

vsm29ST
3-year white DOT tape, 2" x 12" strip

vsm29T
3-year DOT tape, 7" white-11" red, 2" x 18" strip